Popular Articles
When I use teraterm as terminal, I am getting a response with line feed and no carriage return. Can I configure teraterm to view that correctly?
Yes, go to Setup -> Terminal and then change the New-line Receive setting to AUTO
Notes on using Chirpstack
Recommended General Chirpstack Configuration: (LoRaWAN Compliant): -- Make sure to use ChirpStack version >= 3.12.1 -- Set the max data rate to 3 in the Service Profile -- Set enabled_uplink_channels=[0, 1, 2, 3, 4, 5, 6, 7, 64] -- Check the "Disable ...
In order to save power, can the coordinator send a PL command over the air to each endpoint?
No this is not a way to remotely change the power level. Also, we do not allow coordinators to dynamically change the listen window for endpoints. The reason for this is that a sleepy endpoint is typically battery powered and dynamically extending ...
How do I decode an Air Temperature and Humidity event?
The Air Temperature and Humidity Sensor will generate events when the environment changes to exceed set thresholds or on a periodic basis. Air Temperature and Humidity Event Message: 0x0D Byte Description 0 ...
How do I encode a Configuration Downlink for a Thermocouple Temp Sensor?
NOTE: All downlinks must contain a total of (8) bytes, padded with zeros at the end when necessary. See User Manual at https://www.multitech.com/models/RB90000220LF for more information. Byte Bits Description 0 Downlink Message Type (0x13 = ...