How would a radio transmit underflow (error 001C) happen? I’m not getting this error, but I was just wondering what it would mean that I’m doing wrong if I were to see it.

• Related Articles

• How would I get an error 001B? Would the module have to be getting flooded with RF messages? How do I make sure this doesn’t happen?

  This is an internal error condition and there should be no way for a user to cause this. The module is built to be compliant with FCC bandwidth limitations and through the SubGig protocol there should never be a way to cause this.

• "Device ID Already In Use" Error

  Please contact us if this error is encountered when attempting to add sensors to the RadioBridge Console.

• As I’m learning to use the module, I’m sending a lot of data. Is there a way to temporarily disable the governor without just using the Emergency Packet (EP)?

  There is a hidden feature in the firmware to disable the governor, but since this invalidates FCC we do not publish it. If this is necessary, please email support@radiobridge.com to confirm that you understand that this will invalidate FCC compliance ...

• If I’m changing the Session Key, does it matter if I set the upper (KU) or lower (KL) first?

  No it doesn’t matter, you can transmit in either order. When the endpoint receives both the upper and lower half of the key it will enable encryption automatically. Also note that the KU and KL commands are only used to transmit the session key from ...

• Decoding battery information from the supervisory message

  The RadioBridge Sensors use a 3V battery which measures about 3.2 volts when freshly installed. Once the battery depletes to 2.5V the sensor will cease to function. The Supervisory Message periodically sent from the sensor uses the last byte to ...