How would I get an error 001B? Would the module have to be getting flooded with RF messages? How do I make sure this doesn’t happen?

• Related Articles

• How would a radio transmit underflow (error 001C) happen? I’m not getting this error, but I was just wondering what it would mean that I’m doing wrong if I were to see it.

  That would simply indicate an internal error, there is no known way to create this error as a user.

• What is the procedure for sending downlink messages to sensors?

  The recommended way to send a downlink is to use the RadioBridge Console API which uses a simple POST request.  From there you can use the uplink and downlink APIs described in the RadioBridge API Documentation.  To access the API section of the ...

• How do I use the test packets generated by the TP command? Do I get some sort of status report back that tells me the number of packets that were/weren’t ACKed?

  The Test Packets command just puts the device into a test mode that sends a random stream of packets until it is told to stop (ATTP0). The Test Packets command is typically used to measure RF characteristics and the packets are not designed to be ...

• Is there a way to write code for the ARM processor on the Bridgebee module so that I don’t need an external micro to talk to the module?

  No, the BridgeBee is a stand-alone radio module and interfaces to a host through the serial port. Thus, a user may not add application code on the BridgeBee itself. If a stand-alone module is required (such as what we have done with our sensor ...

• When I try to read the BroadcastID Only setting (ATBO) or set it (ATBO0 or ATBO1) I get a reply that the command isn’t recognized (ERR 000A).

  The ATBO command will be removed on the next firmware release. During the Discover Endpoint sequence on the coordinator, any packet from the radio will be used to add the associated endpoint to the list of connected devices. In other words, if the ...