Set a device in sniffer mode and write the configuration to flash, after reset would the device be in sniffer mode?

• Related Articles

• The manual mentions that in sniffer mode, the device ID is reported “of the associated endpoint” (6.4.2.3). Does that mean it cannot sniff message from other coordinators?

  Yes, it will sniff out any packets whether it comes from a coordinator or endpoint. The sniffer is a special diagnostic mode and thus is not operating as either a coordinator or endpoint itself.

• Can I observe the output of ATTP on sniffer?

  No you cannot see this on the sniffer. The ATTP command puts the device into a continuous stream mode that is used for verifying RF characteristics on a spectrum analyzer or other RF equipment.

• How do I decode a sensor's Reset Message?

  The Reset Message is sent to the Cloud every time that the Sensor is Reset. Reset Message: 0x00       Device has Reset. The cause of reset is represented in the 5-byte reset code payload.       Bytes           Description       0                  ...

• How do I set Periodic Reporting to be in hours or minutes?

  Hour/Minute Periodic Reporting is only implemented in firmware 1.3 or greater. Previous versions allow intervals in hours only. Periodic Reporting is a feature available on Temperature Probe/Probeless Sensors as well as Air Temperature and Humidity ...

• How do I encode a Configuration Downlink for an Air Temperature and Humidity Sensor?

  NOTE: All downlinks must contain a total of (8) bytes, padded with zeros at the end when necessary. See User Manual at https://www.multitech.com/brands/reveal-wireless-air-temp-humidity-sensors for more information. Threshold Mode Configuration ...