The user guide mentions a published SubGig spec. Where do I find that?

• Related Articles

• The user guide mentions has a table that gives the Baud, Stop Bits and Parity for the UART connection, but not the number of data bits – is it 8 data bits?

  Yes 8 data bits

• The user guide says that the BridgeBee modules are designed for IoT applications. Can I connect the module to the internet?

  Short answer, no not directly. The moduleis designed for IoT systems requiring wireless monitoring and control. The module itself is an easy to use wireless connectivity product that links gateways to sensors or other endpoint devices that require a ...

• What serial port settings should I use in Tera Term to talk to the SubGig module?

  The SubGig module defaults to 9600 baud for compatibility with older systems and simple Arduino based gateways. Use the following settings: 9600 baud 8 bits data no parity 1 stop bit no flow control Type “AT” without the quotes to see an “CMD_OK” ...

• Where Can I find the AppEUI/JoinEUI?

  Use the following for AppEUI/JoinEUI 01-01-01-01-01-01-01-01 Used in the following product families: RBS301, RBS304, RBS305, and RBS306 78-94-E8-00-00-00-00-00 Used in product families not listed above

• Why do I see two messages when I press the button on a Push-Button Sensor?

  The Push Button Sensors send event messages for both the button press and button release actions. It is possible to configure the sensor so that either press or release messages (or both) are disabled. For more information on Push Button Sensors ...