When I use teraterm as terminal, I am getting a response with line feed and no carriage return. Can I configure teraterm to view that correctly?

• Related Articles

• What serial port settings should I use in Tera Term to talk to the SubGig module?

  The SubGig module defaults to 9600 baud for compatibility with older systems and simple Arduino based gateways. Use the following settings: 9600 baud 8 bits data no parity 1 stop bit no flow control Type “AT” without the quotes to see an “CMD_OK” ...

• What kind of replacement battery should I use for RadioBridge RBS101 and RBS301 Sensors?

  The RadioBridge RBS101 (SigFox) and RBS301 (LoRaWAN) Sensor families all use a single CR123 / CR123A (CR17345) Lithium Battery.  Rechargeable lithium batteries are not suitable for this application. Use only non-rechargeable lithium batteries. ...

• I want to set up the encryption in the field by broadcasting session key, can you give steps/commands which I can use to analyze this feature?

  In order to broadcast the session key in the field, a provisioning key must be set in advance. The provisioning key encrypts the session key and ensures that no unencrypted key is ever broadcast. At the factory or at some point prior to field ...

• "Device ID Already In Use" Error

  Please contact us if this error is encountered when attempting to add sensors to the RadioBridge Console.

• How do I encode a General Configuration Downlink message?

  A downlink message is one that is sent to the sensor from the cloud and is used to configure the sensor itself.  Messages cannot be initiated from the cloud since the sensor is typically sleeping and the radio is turned off, so the sensor itself must ...