How do I use the test packets generated by the TP command? Do I get some sort of status report back that tells me the number of packets that were/weren’t ACKed?

• Related Articles

• When I try to read the BroadcastID Only setting (ATBO) or set it (ATBO0 or ATBO1) I get a reply that the command isn’t recognized (ERR 000A).

  The ATBO command will be removed on the next firmware release. During the Discover Endpoint sequence on the coordinator, any packet from the radio will be used to add the associated endpoint to the list of connected devices. In other words, if the ...

• Is there a test mode I can place the module in to verify that I have a radio output?

  Yes, use the Test Carrier (TC) AT command. To turn the test output on send the module “ATTC1” and to turn it off send it “ATTC0”. The test carrier will stay on until it is turned off or power cycled. Do not use this mode on battery powered devices as ...

• Is there any AT command I can send the module to cause it to reboot?

  There isn’t a reboot command that is the equivalent of pulling reset low, but you can use the RE (restore parameters) or FR (factory reset) to reset all parameter values to default. Note that the difference between the two is that FR also clears the ...

• Does the coordinator know which endpoints are sleepy ones, and can it give me a list of which ones are/aren’t?

  In the next firmware release v1.02 we will have the command ES which will report endpoint status including the sleep mode of the endpoint.

• Instead of sending the SK in 2 AT commands (KU and then KL), is there some AT command that allows it to be sent as one command?

  There is no command which sends both parts automatically, they must be sent individually. Also, it doesn’t matter which order they are sent, as long as both parts of the key are received by the endpoint, encryption will be enabled automatically.