Is there a way to make the coordinator set the Supervisor Timeout in the endpoints when the coordinator has its Supervisor Timeout changed?

• Related Articles

• Can the coordinator remotely change the Listen Window in endpoints?

  No we do not allow coordinators to dynamically change the listen window for endpoints. The reason for this is that a sleepy endpoint is typically battery powered and dynamically extending the listen window in the field could unexpectedly and ...

• I want to set up the encryption in the field by broadcasting session key, can you give steps/commands which I can use to analyze this feature?

  In order to broadcast the session key in the field, a provisioning key must be set in advance. The provisioning key encrypts the session key and ensures that no unencrypted key is ever broadcast. At the factory or at some point prior to field ...

• In order to save power, can the coordinator send a PL command over the air to each endpoint?

  No this is not a way to remotely change the power level. Also, we do not allow coordinators to dynamically change the listen window for endpoints. The reason for this is that a sleepy endpoint is typically battery powered and dynamically extending ...

• Does the coordinator need to have its sleep mode enabled to send queued packets to sleepy endpoints?

  No and you typically don’t want to put the coordinator into sleep mode. When the queue packet command is used the coordinator will check to see if the endpoint is sleepy, and if it is not then it will send the message immediately. In other words, the ...

• What is the difference between a coordinator and an endpoint?

  The SubGig standard defines a very simple star topology where one coordinator device speaks to multiple endpoints. The coordinator is generally controlled by a host processor, typically on a gateway connected to the cloud. A device acting as a ...