Is there a way to write code for the ARM processor on the Bridgebee module so that I don’t need an external micro to talk to the module?

• Related Articles

• The user guide says that the BridgeBee modules are designed for IoT applications. Can I connect the module to the internet?

  Short answer, no not directly. The moduleis designed for IoT systems requiring wireless monitoring and control. The module itself is an easy to use wireless connectivity product that links gateways to sensors or other endpoint devices that require a ...

• How would I get an error 001B? Would the module have to be getting flooded with RF messages? How do I make sure this doesn’t happen?

  This is an internal error condition and there should be no way for a user to cause this. The module is built to be compliant with FCC bandwidth limitations and through the SubGig protocol there should never be a way to cause this.

• How do I decode an External Probe Temperature Sensor Event?

  The External Probe Temperature Sensor will generate events if the temperature rises above or falls below the configured thresholds.   Byte 0: 7-4 Byte 0: 3-0 Byte 1 Byte 2    Byte 3 Byte 4 Protocol version     (4 bits) Counter       (4 bits) ...

• What serial port settings should I use in Tera Term to talk to the SubGig module?

  The SubGig module defaults to 9600 baud for compatibility with older systems and simple Arduino based gateways. Use the following settings: 9600 baud 8 bits data no parity 1 stop bit no flow control Type “AT” without the quotes to see an “CMD_OK” ...

• What is the relation between SLEEP_RQ pin and sleep mode AT code, do I need both to enter sleep mode?

  Yes, you need to first enable sleep mode on the endpoint using the command:   ATSM1   and then pull the SLEEP_RQ pin high to enter sleep. Pull the pin low to exit sleep mode.