The user guide mentions has a table that gives the Baud, Stop Bits and Parity for the UART connection, but not the number of data bits – is it 8 data bits?

• Related Articles

• The user guide mentions a published SubGig spec. Where do I find that?

  The SubGig specification has not yet been published, however a brief description of the topology is given in the user guide.

• What serial port settings should I use in Tera Term to talk to the SubGig module?

  The SubGig module defaults to 9600 baud for compatibility with older systems and simple Arduino based gateways. Use the following settings: 9600 baud 8 bits data no parity 1 stop bit no flow control Type “AT” without the quotes to see an “CMD_OK” ...

• The user guide says that the BridgeBee modules are designed for IoT applications. Can I connect the module to the internet?

  Short answer, no not directly. The moduleis designed for IoT systems requiring wireless monitoring and control. The module itself is an easy to use wireless connectivity product that links gateways to sensors or other endpoint devices that require a ...

• How do I encode a downlink for an ABM (Acceleration Based Movement) Sensor?

  NOTE:  All downlinks must contain a total of (8) bytes, padded with zeros at the end when necessary.   See User Manual at https://www.multitech.com/brands/reveal-wireless-movement-sensors for more information. ABM sensor Configuration Message: 0x0E ...

• How do I use the test packets generated by the TP command? Do I get some sort of status report back that tells me the number of packets that were/weren’t ACKed?

  The Test Packets command just puts the device into a test mode that sends a random stream of packets until it is told to stop (ATTP0). The Test Packets command is typically used to measure RF characteristics and the packets are not designed to be ...